XC70 Limp Mode » Relationships » Our Forum
Our Forum

Our Forum



ПоискПоиск   Users   Registration   Entrance
Today: 08.06.2025 - 04:14:11
Pages:  1  

XC70 Limp Mode

Advertising


MessageAuthor

Hi Clutching at straws here. XC70 2004 with T5 engine 90,000 miles,car will start and run no problem but when you drive it and give it a quick boot it goes into limp mode and message "engine system service urgent" ,stop engine and start again it's back to normal until you boot it again. Put scanner on it and that comes up with "high fuel pressure" and "slight fuel leak detected" live data gives you a fuel pressure reading of 35000 kpa at idle and 43000 at 2500rpm,not sure what reading should be. Have cleaned pressure regulating valve and fitted new pressure switch also had injectors cleaned and tested all to no avail. Any Ideas???

---------------------

BitchWitch

users




Statistics:
Messages: 11
Registration: 03.10.2006
07.12.20 - 08:50:14
Message # 1
RE: XC70 Limp Mode

same as 

---------------------

turina

users




Statistics:
Messages: 1454
Registration: 23.09.2009
07.12.20 - 08:58:30
Message # 2
RE: XC70 Limp Mode

help mine does this.any outcome?

---------------------

LORD_KEA

users




Statistics:
Messages: 10
Registration: 29.12.2007
07.12.20 - 09:02:57
Message # 3
RE: XC70 Limp Mode

Could you confirm the engine type, I dont think the T5 engine was ever fitted to the XC model. Is it a 2.4T or 2.5T? engine code would help (it's on the cam belt cover). Could you also post the actual fault code numbers please?

---------------------

yuli_mos

users




Statistics:
Messages: 1
Registration: 26.08.2010
07.12.20 - 09:10:42
Message # 4
RE: XC70 Limp Mode

eng code d5244t 

---------------------
иногда бывает так больно...я на небесах=)

Skippy

users




Statistics:
Messages: 102
Registration: 26.05.2005
07.12.20 - 09:14:47
Message # 5
RE: XC70 Limp Mode

hi chris , my codes are ecm 1300 maf signal too high ,2501 fuel press too high ,2503 fuel press too low ,2505 fuel press too low. new maf fitted. ecm1300 still remains , rest of codes erased. also have oil loss/stain around air filter hoses.any connection ? thanks sticks

---------------------

flowersAngel

users




Statistics:
Messages: 671
Registration: 18.05.2010
07.12.20 - 09:18:07
Message # 6
RE: XC70 Limp Mode

Don't think we are talking about the same problem here. If I understood correctly the OP has a petrol engine and poster sticks has a diesel. Sticks I suggest you start a new post with your problem, with full symptoms etc, as this is going to get confusing otherwise.

---------------------
Lorem ipsum dolor sit amet, consectetur adipiscing elit. Praesent convallis, libero a consequat congue, orci quam porta leo, non placerat lacus erat sit amet orci.

wnderson13

users




Statistics:
Messages: 81
Registration: 17 lip 2012, 6:23
07.12.20 - 09:22:45
Message # 7
RE: XC70 Limp Mode

origanal tread posted in diesel engines 

---------------------
IP 10.128.170.146

xxxxangelxxxx

users




Statistics:
Messages: 25
Registration: 26.11.2006
07.12.20 - 09:31:16
Message # 8
RE: XC70 Limp Mode

can be found in diesel engines. symptoms steep hills/kickdown goes into limp mode.engine service required when ignition turned on.mass air flow signal too high ecm 1300 will not clear.no fuel filt change for 20k.worried about split intercooler as have oil leak at front around air filt pipes/hoses.ecm2501 ,2503, 2505 all cleared

---------------------
Ein paar Impressionen meines NIU N1S seht Ihr hier: [br]

niu.berlin

users




Statistics:
Messages: 4
Registration: Do 23. Mai 2019, 11:52
07.12.20 - 09:37:58
Message # 9
RE: XC70 Limp Mode

---------------------



users




Statistics:
Messages:
Registration:
01.01.70 - 03:00:00
Message # 10
RE: XC70 Limp Mode
VST Spring Cleaning : Previous topicNext topic: RME FF800 and Vista 64
Pages:  1  

The administrator has prohibited guests from replying to messages! To register, follow the link: register


Participants